Komatsu — BLEEDING AIR FROM HYDRAULIC SYSTEM

. MAINTENANCE MAINTENANCE PROCEDURE 4 - 41 5. Bleeding air fr om travel moto (Bleed the air only when the oil inside t he travel m otor case h as be 1) Run the e ngine at low id and check tha 2) Run the e ngine at low idl e and swing the wor k equipmen 90° to brin g it to the side of the track. 3) Jack up t he machine unti l the trac k is slightly from the groun d. Rotate the tra ck under no load for 2 minutes. Repeat th is procedure on both the left and rig ht sides. 6. Bleeding air fr om attachment (when installed) I f a breaker or other attachme nt has been i nstalled , run the engine a t low idle and o perate the attachm ent pedal repeatedly (a pprox.

10 times) until the air has bee n bled from the a ttachment circ uit. NOTICE If the method of bleeding the air f rom the attachment its elf is specified by t he manufacturer , bleed the air accor ding to the specified proced ure. After completing the air bleeding o peration, stop the engi ne, and leave the m achine for 5 min utes before starting operations. This will remove the air bubbles in the oil inside the hydr aulic cylinders. d. l level is low, add oil. Chec k that there is no leakage of o il and wip e of f any oil that has been spille After completing the air bleeding o peration, i nspect the o il level, and i f the oi l level is low, ad