. MAINTENANCE MAINTENANCE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 49 The parts and oil ar e at high temperature immediately after t he engine is stopped, and may cause s erious burns. Wait fo r the temperature to go down before starting t he operation. If there is still pres sure remaining inside the case , the oil or plug may f ly Loosen the plug sl owly to release the pre Prepare a handle 1. Set the TOP m perpendicular to the ground surfac 2. Remove plug (F ) using the handle. When t he oil leve l reaches a point 10 mm (0.4 in) below the b correct amount of oil has been add 3.
If the oil level i s too low, install p e forward or in rev lug (F), levers, and driv erse to one turn. Then repeat Step 2 to ch eck again. 4. If the oil level is low, add engine oil throug h plug hol e (F) unti the oil overflow s from plug hole (F) 5. After checking, install plug (F). Tightening torque for plugs (F): 68. N 6 ± 7.2 REMARK There are two plugs (F). Add oil through the one easier to fill oil and through which no in ternal gears are to be seen .