. MAINTENANCE MAINTENANCE PROCEDURE CHECK FAN BELT, ALTERNATOR BELT TENSION, ADJUST Inspection (A): Alternator pulley (B): Fan pulley (C): Crankshaft pulley 4 - 53 LUBRICATE SWING CIRCLE pment to the ground. mp, pump in grease through the grease ows. (2 places) off any old grease that was pushed out. 1. 2. 3. 1. Lower the work equi pment to the ground 2. Using a grease pu mp, pump in grease fittings shown by arr 3. After greasing, wipe off any old grease th at was pus hed out. The lt should be approx. in) when pressed with a finger for ce of approx. 58.8N ( 6 kgf) at mid -point (a) between the alternator p ulley and the fan pul Adjustment ts (1), (2), (3).
se to move alternator (5) so that the belt 1. Loosen bolts and nu Turn nut (4) clockwi deflects by approx. 1 6 kg (58.8 N). 2. Tighten bolts and nu Tightening torque Lock nut(1) and (4): Bolt(2): 33.3 ± 4.9N· Bolt(3): 127.4 ± 19.6 1. Loosen bolts and nu Turn nut (4) clockwi se to move alternato deflects by approx. 1 3 mm (0.5 in) with ap plied force o f approx. 6 kg (58.8 N). 2. Tighten bolts and nu ts (1), (2) and (3) to secure alter nator (5). Tightening torque Lock nut(1) and (4): 137.2 ± 53.9 N·m (1 4 ± 5.5kgf·m , 101.3 ± 39.8 lbft) m (3.4 ± 0.5kgf·m, 24.6 ± 3.6 lbft) N·m (13 ± 2kgf·m, 94.0 ± 14.5 lbft) Bolt(2): 33.3 ± 4.9N· m (3.4 ± 0.5kgf·m, 2 4.6 ± 3.6 lbf Bolt(3):
127.4 ± 19.6 N·m (13 ± 2kgf·m, 9 4.0 ± 14.5 lb