. MAINTENANCE MAINTENANCE PROCEDURE for 10 minutes. 11. Stop the engine. 12. Check for oil leakage and wipe off any spilled oil. CHANGE OIL IN SWING MACHINERY CASE WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. 4 - 69 10. To bleed the air, start th e engine according to "STARTIN G ENGINE (P AGE 3-72)" and run the engine at low idle REMARK Wait for at least 5 minutes after stopping the eigine to eliminate bubbles i n the oil inside the Refill capacity: 20 liters 1. Remove cover (A) of t (Only machines equipp 2.
Set a container under drain valve (P) under the machin e body to catch the oil. 3. Loosen drain valve (P ) under the body, drain the oil, then again. and air bleding plug (2), then add the tighten the drain valve 4. Remove dipstick (G) he specified amount of o guide. il through filler port (F) of the dipstick air bleed plug (2). ipstick 5. After adding oil, install 6. Pull out dipstick (G) an d wipe off oil on the dipstick with cloth. 7. Fully insert dipstick (G ) into filler pipe (F), then remove i t. 8. The oil level should be between H and L marks on the d ipstick (G). If the oil does not r port (F). each the L mark, add oil through oil filler 9.
If the oil is above the H mark, drain the excess engine oil from drain valve (P), and ch When draining the o hole (B), then turn th eck the oil level again. il, first pull hose (1) out from inspection e drain valve to the OPEN position.