Komatsu — REPLACE HYDRAULIC OIL FILTER ELEMENT

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING and may cause burns. Wait for the NOTICE If the machine is equipped with a operations. For details, see maintenance. REMARK 4 - 68 emperature to go down before st When removing the oil filler cap, turn it slowly to release the internal pressure, then ydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket NTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17) " when carrying out Set the work equipment on the hard and flat ground in the maintenanceposture as sho ground and stop the engine.

wn in the figure, then lower it to the Remove the cap from oil fille r (F) on top of the hydraulic tank, and release the internal pres sure. cover (1). Loosen 4 bolts, then remove When doing this, the cover m (2), hold the cover down wh ay fly out under the force of spring en removing the bolts. If th as e mounting bolts of cover (1) it is for approx. 5 minutes, are loosened and the cover is left the pressure inside the case is released, so the oil in the elemen t is drained and less oil drips when the After removing spring (2), v element (5). alve (3) and strainer (4), take out diesel oil. Clean the removed parts in Install the new element in the place where old element (5) was installed.

on top of the element. Set valve (3) and spring (2) Set cover (1) in position, pus h it down by hand, and install the cover with the mouning bolts . install the cover. Screw in the oil filler cap and