. MAINTENANCE MAINTENANCE PROCEDURE CLEAN HYDRAULIC TANK STRAINER WARNING cause burns. Wait for the CLEAN ENGINE BREATHER WARNING 4 - 74 temperature to go down bef When removing the oil filler cap, turn it slowly to release th e internal pressure, then remove it. 1. Remove 4 bolts, then remove cover (1). When doing this, cover (1) may fly out un der the force of spring (2), s o keep the cover pressed down w hile removing the bolts. and pull up to remove spring (2) and to strainer (4), then wash it in flushing 2. Hold the top of rod (3) strainer (4). Remove any dirt stuck 3. in flushing oil. If strainer (4) is dam aged, replace it with a new part. 4.
When installing, insert s trainer (4) into protruding par t (5) of the tank, and assemble. 5. Assemble so that the pr otruding part at the bottom o f cover (1) holds spring (2), then ti ghten with the bolt. The parts and oil are at high temperature after the engine is stopped, and may cause serious bu rns. Wait for the temperature to go down before cleaning the engine breather. r, there is a hazard that dirt may be blown up and cause serious injury. dust mask, or other protective equipment. When using compressed ai r, there is a hazard that dirt may be blown up and cause serious inj Always use safety glasses, dust mask, or other protective e quipment 1. Wipe away dust around the breather. 2.
Loosen the clamp (1), r emove the breather hose, th en remove breather (2) from the cy linder head cover. y with light oil or cleaning oil. 3. Clean the breather bod y with light oil or cleaning oil 4. Replace O-ring with ne oil, set it, then install br w one. Coat a new O-ring with engine eather (2). 5. Check the breather hos to insides, replace the e and pipe. If caked oil (sludg hose and pipe with new part e) adhere s.