. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING REMARK with new ones. in the exhaust gas color, contact your 4 - 73 EVERY 2000 HOURS MAINTENANC Maintenance for every 250, 500 and 1000 ho urs servic e should b e carried out at the same time. The parts and oil are a t high temperature immediately after t he engine is stoppe d, and may cause s erious burns. Wait fo r the temperature to go dow n before starting the ope ration. If there is still pressur e remaining inside the ca se, the oil or plug may fly Loosen the plug slowl y to release the pressure. Refill capacity: each 12 liters (3.17 US gal Prepare a handle. 1. 2. 3. 1.
Set the TOP mark at the top, with the TO P mark an d plu g (P perpendicular to th e ground surface. e oil. e and drain the oil. 2. Set a container un der plug (P) to catch th e oil. 3. Remove plugs (P) and (F) with the handl e and drain the o he plugs for damage. I f necessar 4. Tighten plug (P). hole of plug (F). 5. Add oil through the 6. When oil begins to overflow from the plug (F) hole, i nstall plug (F). of plugs (P) and (F): ± 1 kgf·m, 50.6 ± 7.2 lbft) Tightening torque 68.6 ± 9.8 N·m (7 ± 1 kgf·m, 50.6 ± 7.2 lb REMARK There are two plugs (F ). Add oil through the o ne easier to fill oil and through which no inter nal gears are to be se en.
CHECK INJECTOR Check the color of the Komatsu distributor fo For details, see "TRO UBLES AND ACTION S (PAGE 3 -129)" "Exhaust co