Scania — Crankshaft seal

Engine Tier-3 710655- Ch 1 page 104 Fitting 1. Wipe clean the seal seat in the housing. Note The crankshaft seal should be fitted dry and must not be lubricated. The sleeve inside the seal must not be removed until immediately before the seal is fitted in the engine. 2. Use assembly tool 98 721 to press in the seal. This tool is tapped in using a copper hammer. 3. Degrease the surface of the oscillation damper hub in contact with the seal and drive on the hub using drift 87 509. 4. Fit the crankshaft bolt with washer 98 133 but without the cone in the hub. Tighten the crankshaft bolt to 300 Nm. 5. Remove the crankshaft bolt and washer 98 133 and fit the cone.

Screw in the crank- shaft bolt with attendant washer. Tighten first to 300 Nm and then a further sixth of a turn (60°) using slogging wrench 99 059. 6. Fit the oscillation damper and, if fitted, the belt pulley. Tighten the bolts to 110 Nm. 7. Refit the components that were removed ear- lier because they were in the way. 1. Oil deflector 2. Seal 3. Timing gear cover -31 - 06.2005