Engine Tier-3 710655- Ch 1 page 105 Timing gear cover Removing 1. Remove components that are in the way: radiator, fan ring, fan, belt guard, alternator, V -belt, belt tensioner, tensioning rollers, fan drive, alternator bracket. 2. Turn the engine over to the ignition position. 3. Undo the crankshaft damper bolts and those for the belt pulley, if fitted. Remove the crankshaft damper and belt pulley, if fitted. Take care to avoid damaging the crankshaft damper. 4. Remove the crankshaft bolt in front of the damper hub. Use slogging wrench 99 059. 5. Fit support drift 87 663 in the end of the crankshaft. 6. Screw on puller 87 665 with all six bolts. Pull the hub out 2-5 mm.
Then unscrew the bolt a few turns and tap the hub in to loosen the cone. 7. Pull the hub off altogether. 8. Remove the seal using slide hammer 87 596. Protect the end of the crankshaft against scratches. 9. Engine equipped with compressor: Remove the coolant manifold between the coolant pump and compressor. 10. Undo the three compressor retaining bolts in the timing gear housing. Extract the compres- sor and gear. SHOP MANUAL MT26-31 - 06.2005