Scania — Timing gear cover

Engine Tier-3 710655- Ch 1 page 106 11. Check that the engine is in the ignition posi- tion. 12. Remove the oil sump. 13. Remove the timing gear housing. Fitting 1. Clean the mating surfaces and fit a new gasket. 2. Fit the timing gear housing in place and tighten the bolts to a torque of 39 Nm. 3. Fit a new crankshaft seal. See Crankshaft seal: Fitting. 4. Drive on the oscillation damper hub using drift 87 509. 5. Fit the crankshaft bolt with washer 98 133 but without the cone in the hub. Tighten the crankshaft bolt to 300 Nm. 6. Remove the crankshaft bolt and washer 98 133 and fit the cone. Screw in the crank- shaft bolt with attendant washer.

Tighten first to 300 Nm and then a further sixth of a turn (60°) using slogging wrench 99 059. 7. Fit the oil sump with a new gasket. 8. Refit the components that were removed ear- lier because they were in the way. SHOP MANUAL MT26-31 - 06.2005