Engine Tier-3 710655- Ch 1 page 107 Intermediate gear Removing 1. Remove the timing gear cover. See Timing gear cover: Removing. 2. Remove oil catcher from end of crankshaft. 3. Turn the crankshaft so that the marks on the camshaft gear and crankshaft gear point towards the centre of the intermediate gear. 4. Remove the intermediate gear. Note After the intermediate gear has been removed, the camshaft and crank- shaft must not be moved. Pistons and valves could then strike each other and sustain damage. Fitting 1. Lubricate the bearing surfaces and fit the intermediate gear and thrust bearings so that all marks are in the correct positions. 2.
Fit the washer and tighten the bolts to a torque of 39 Nm. 3. Fit the oil catcher on the end of the crankshaft. 4. Fit the timing gear cover. See Timing gear cover: Fitting. SHOP MANUAL MT26-31 - 06.2005