Scania — Camshaft

Engine Tier-3 710655- Ch 1 page 110 Camshaft Removing - It is assumed that the timing gear housing has already been removed. 1. Remove rocker arms and pushrods. 2. Turn crankshaft around until the tooth marked on the crankshaft gear and camshaft gear point towards the centre of the intermediate gear. In this position, the camshaft guide flange bolts can be accessed through the holes in the camshaft gear. 3. Remove the side covers with valve tappets. 4. Undo the camshaft gear retaining nut. The camshaft gear can now be pulled off the cam- shaft using puller 587 315 or can be left in place when the camshaft is extracted. 5. Remove the intermediate gear and the guide flange bolts. 6.

Extract the camshaft from the front. Take care to avoid damaging cams and bearings. Fitting 1. Lubricate and push in the camshaft. Becareful not to damage cams and bearings. 2. Fit the guide flange bolts. 3. Fit the intermediate gear, see Intermediate gear: Fitting, points 1-2. 4. Fit the camshaft gear, 5. Lubricate the camshaft cams. Fit the side cov- see Camshaft gear: Fitting, points 1-4. ers with a new gasket. 6. Lubricate pushrods and rocker arms with motor oil and fit them in place. SHOP MANUAL MT26-31 - 06.2005