Engine Tier-3 710655- Ch 1 page 111 Changing valve tappets 1. Clamp the side cover in a vice. Remove the retaining ring and valve tappet. 2. Fit a new valve tappet. Fit the retaining ring, using a screwdriver. Camshaft bearings - There is very little wear on the camshaft and camshaft bearings andthesecomponents rarely need any work to be done on them. - However, when reconditioning the engine, check that the bearing surfaces and cams are not abnormally worn. - Fit new bearings so that the lubricating holes are opposite the oilways in the block. Checking camshaft setting 1. Set the crankshaft at TDC for No. 1 cylin- der’s compression stroke (valves closed). 2.
Set up two dial gauges against the valve spring thrust washers. 3. Adjust the rocker arms so that there is no clearance and then an additional 0.1 mm (see that both valves are open 0.1 mm). 4. Zeroize both dial gauges. 5. Turn the crankshaft one revolution in its direction of rotation until the TDC position is reached again. 6. Read the two dial gauges and compare the results with the values given below: Intake valve lifting height 0.55-1.65 mm Exhaust valve lifting height 0.50-1.50 mm SHOP MANUAL MT26-31 - 06.2005