Engine Tier-3 710655- Ch 1 page 114 Lubrication system Oil pump An oil pump, driven by the crankshaft gear, generates the circulation required to provide lubrication oil to all lubrication points so that it flows through the oil cleaner and oil cooler. The lubricating oil is sucked from the sump through a strainer in the oil pump. The oil pressure must be so high as to ensure that each lubrication point receives the amount of oil needed for its lubrication and cooling. Too high oil pressure could cause excessive stress to components in the lubrication system. 1.
Oil pump Particularly when the oil is cold there is a risk that the pressure will be high and for this reason a safety valve is incorporated in the oil pump. If the pressure is too high the oil pressure valve will allow oil to escape (and run back to the sump) so that the pressure will not be so high as to cause any damage. 1. Oil pump 2. Flange bolt 3. Gasket 4. Flange bolt 5. Suction pipe 6. Strainer 7. Ring 8. Flange bolt 9. Pipe 10. Seal NOTE! In the case of leakage or fault in the oil pump, it should not be recondi tioned but should be renewed as a unit. SHOP MANUAL MT26-31 - 06.2005