Scania — Crankshaft

Engine Tier-3 710655- Ch 1 page 113 Fitting 1. Be particularly careful to clean all oilways in the crankshaft, pivot pins and contact sur- faces for bearings and caps. 2. Check that the dimensions of bearings and thrust washers are correct. Fit the bearing halves in block andcap. Generously lubricate bearings and pivot pins. 3. Carefully lift in the crankshaft. Fit the thrust washers and place the caps as marked. 4. Lubricate the bolt threads and start by tight- ening the cap bolts to 90 Nm. The tighten the bolts to 290 Nm. Check that the crankshaft rotates easily. 5. Check crankshaft axial clearance. It should be 0.14-0.37 mm.

The clearance can be adjusted by changing the thrust bearing washers. 6. Fit pistons, connecting rods and oil pump. 7. Fit the fan bearing and fan, oil sump, timing gear housing and intermediate gear. 8. Fit the flywheel and flywheel housing. 9. Fit the cylinder heads and pushrods. SHOP MANUAL MT26-31 - 06.2005