Scania — View of the radiator system

Engine Tier-3 710655- Ch 1 page 128 Circulation From the pump, the coolant is carried into the cyl­inder block’s longitudinal distribution ducting and then through holes in the cylinder block, washes round the cylinder liners and flows up to the cylinder heads. The coolant is also forced directly up into the cyl­inder heads from the distribution ducting via pas­sages which leads to the injectors and exhaust valves. From the engine’s rear cylinder head the coolant flows forward through the pipe directly into the thermostat housing, which is located on the left-hand side of the radiator shield.

The by pass in the thermostat housing forwards the coolant which is under the temperature limit for the ther­ mostat, back to the engine through the transmission cooler. The coolant which needs to be cooled, are going through the open thermostat and to the radiator cooler system, through the transmission cooler and back to the engine, where the coolant pump is circulating the coolant in the system. The cab heater takes the heat coolant from the pipe line on the left-hand side of the engine, and after heating the cab, the returned coolant is going to the transmission cooler. The inlet air to the engine, is by the turbo compressor forced through the charge air cooler.

The hydraulic driven fan are also feeding the air through the air charge cooler and cools the air from the turbo compressor. The pressure of the air, in the air charge system, to the cylinders is approx 1 - 2 bar, depend on the engine’s rpm. View of the radiator system 3 Engine cooler 6 Air condition condenser 1 Thermostat housing 4 Charge air cooler 5 Transmission cooler 2 Radiator shield SHOP MANUAL MT26-31 - 06.2005