Scania — Disassemble the cooling unit

Engine Tier-3 710655- Ch 1 page 129 Disassemble the cooling unit 1 Drain the coolant and transmission oil. First, remove both cover on the underside front frame left and right side. 1 On left side of the transmission cooler unscrew the plug (Nv 13 mm) and drain the coolant from the engine and radiator. On the right side under the transmission cooler unscrew the plug (Nv 13mm) and drain the transmission oil from the system. NOTE ! Use a clean drum or similar if the cooling water shall be reused. Its recommend to supply with new oil when refilling oil to the transmission. 2 Disassemble the horn unit, remove the fastening wiring strips and clamps from the brackets.

3 Disconnect the cooling hoses from the thermostat housing and the outlet hose from the transmission oil cooler. 4 Disassemble the hose on the charge air cooler 5 Disconnect hoses between the expansion tank and the engine. 5 Disassemble oil hoses from the transmission oil cooler and the fan motor. NOTE ! Oil under hydraulic pressure ! The oil system for the fan motor is in the same oil system as the brake, therefore it is recomended when disassemble hoses or units from this system, allways to eliminate pressure in the accumulator, locate in front of the cab. (2 on left and side 2 on the right side). this can be doing with to operate the brake pedal sev­ eral times.

(Approx 15-20 times) SHOP MANUAL MT26-31 - 06.2005