Engine Tier-3 710655- Ch 1 page 137 External cleaning Radiator - Check that the radiator is not clogged on the air side and that the cooling fins are not damaged. - Carefully scrape the deposit off the radiator’s cooling fins. If necessary, a paraffin-based engine cleaner can be used. - Bent fins can be straightened using a wire brush, for example, and exercising care. Internal cleaning Removing oil and grease - If possible, run the engine until it has reached the operating temperature and then drain the cooling system. - Remove the thermostat. - Fill the system with clean, hot water mixed with liquid dishwasher detergent intended for household use. Concentration 1% (0.1/10 l).
- Run the engine until warm for about 20-30 minutes. Do not forget the cab heating system (if fitted). - Drain the cooling system. - Fill the system again using clean, hot water and run the engine for approximately 20-30 minutes. - Drain the water from the system. - Refit the thermostat. - Fill up with new coolant according to the specification on page 3 3. Handling cleaning agents for the cooling system: Read the warning label on the container. Removing deposits - If possible, run the engine until it has reached operating temperature and then drain the cooling system. - Remove the thermostat.
- Fill the system with clean, hot water mixed with a commercially available radiator cleaner based on sulphamic acid and containing dispersing agents. Follow the manufacturer’s instructions for mixing proportions and cleaning times. - Run the engine for the specified time and then drain the cooling system. - Refill the system with hot water and run the engine for approximately 20-30 minutes. - Drain the water from the system. - Refit the thermostat. - Fill up with new coolant according to the specification on page 33. Always collect fluid in a suitable container to avoid spillage when draining coolant. Dispose of used coolant through an authorized waste disposal contractor.
SHOP MANUAL MT26-31 - 06.2005