Scania — Low oil pressure

Engine Tier-3 710655- Ch 1 page 151 Low oil pressure Continue next page SHOP MANUAL MT26-31 - 06.2005 Effect Cause Troubleshooting Action Gauge shows low pres­ sure Crankshaft bear­ing/ main bearing of wrong size has been fit­ted on reground crank­shaft Max. oil pressure 2 bar also when engine cold Change to bearings of the correct size. Check the bearing seats be­ fore assembly Excessive play in big- end and main bearings Seizing in camshaft bearings If the bushing slides all the way out of the bear­ing seat, the oil pressure warning lamp will come on.

The engine throws out oil through the crank­ case ventilation Piston cooling nozzle has come loose Suction pipe to oil pump has come loose, the pump sucks air Extremely low lubricat­ ing oil viscosity Worn bushings or loose shaft in oil cleaner Choose a viscosity that is suitable for the ambi­ ent temperature Change rotor if bush­ing is worn oval Change worn/dam­aged shaft Broken O-ring on cy­ clone part of oil cleaner Defective oil pump drive Internal leakage in oil cleaner Defective sensor/instru­ ment Check that the oil cleaner is correctly as­ sembled Take a reading of the oil pr engine using a mechanical on the engine:

Minimum 1 bar at 800 r/mi Maximum 6 bar > 800 r/mi essure on warmed-up pressure gauge directly n. n. Incorrectly adjusted oil relief valve 1 shim = 0.2 bar Check/remedy relief valve Broken spring in oil relief valve Max. oil pressure 2 bar at 2000 r/min The piston in the oil re­ lief valve has jammed in open position