Scania — Abnormal wear (liner, piston rings, etc.)

Engine Tier-3 710655- Ch 1 page 153 High oil pressure (Engine warmed up) Abnormal wear (liner, piston rings, etc.) SHOP MANUAL MT26-31 - 06.2005 Effect Cause Troubleshooting Action Gauge indicates high pressure Defective sensor/ instru­ment Take a reading of the oil pressure on the warmed- up engine using a mechanical pressure gauge directly on the engine: Minimum 1 bar at 800 r/min. Maximum 6 bar > 800 r/min.

Oil viscosity too high Choose a viscosity that is suitable for the ambi­ ent temperature Gauge indicates high pressure Incorrectly adjusted oil relief valve 1 shim = 0.2 bar Piston in oil relief valve jammed in closed posi­ tion Valve in oil duct to pis­ ton cooling nozzles is binding Effect Cause Troubleshooting Action Short service life Unclean intake air due to leakage in intake piping Wrong grade of oil, pol­ ishing damage Changing of filters and oil has been neglected Low coolant tempera­ ture (cold engine) Excessive sulphur con­ tent in fuel Change the fuel Change to oil with a higher base number. Shorter oil change intervals Defective injector (causes oil film to be washed off)