Engine Tier-3 710655- Ch 1 page 34 How to erase fault codes from the ECU control unit The control unit memory has sufficient space to store 40 fault codes. The fault codes are stored in two different places in the control unit. Erasing with the diagnostic switch erases the fault codes that are flashed on the diagnostic lamp. However, the fault codes will remain in another memory which can only be accessed using a ECOM. Both fault code memories are erased at the same time with ECOM. How to erase fault codes during pre-delivery inspection Fault codes are to be erased with ECOM during pre-delivery inspection so that both memories are empty when the engine is delivered to the customer.
How to erase fault codes using the diagnostics switch How to erase fault codes that are flashed on the diagnostic lamp is described below. The fault codes are still stored elsewhere in the control unit. These fault codes are erased with ECOM. 1 Start and switch off the engine once so that a shutdown test is carried out. Wait until the ECU warning lamp has gone out. 2 First press and hold the diagnostics switch, then turn the starter key to the drive position. Keep pressing the diagnostics switch for between 3 and 10 seconds. The passive fault codes will then have been cleared. When the engine is started again, the fault codes that are active will be shown again.
3 Start the engine and check that the diagnostics lamp goes out. 4 Press the diagnostics switch. The fault code memory should be empty; only one long flash should be seen. SHOP MANUAL MT26-31 - 06.2005