Scania — Flash codes tables

Engine Tier-3 710655- Ch 1 page 35 Flash codes tables This is a list of the flash codes which can be read and the fault codes to which they correspond. One flash code in ECU S6 corresponds to several different fault codes. SHOP MANUAL MT26-31 - 06.2005 Flashing code list for the EMS control unit Code Description Code Description 0 No fault detected. 53 PDE in cylinder 3: The solenoid valve does not work correctly. 11 Overspeed. One or both engine speed sensors are displaying speeds in excess of 3000 r/min. 54 PDE in cylinder 4: The solenoid valve does not work correctly. 12 Engine speed sensor 1 faulty, or incorrect signal. 55 PDE in cylinder 5: The solenoid valve does not work correctly.

13 Engine speed sensor 2 faulty, or incorrect signal. 56 PDE in cylinder 6: The solenoid valve does not work correctly. 14 Coolant temperature sensor faulty, or incorrect signal. 57 PDE in cylinder 7: The solenoid valve does not work correctly. 15 Charge air temperature sensor faulty, or incorrect signal. 58 PDE in cylinder 8: The solenoid valve does not work correctly. 16 Charge air pressure sensor faulty, or incorrect signal. 59 Incorrect signal in extra analog input. 17 Oil temperature sensor faulty, or incorrect signal. 61 Incorrect control unit shutdown. 18 Oil pressure sensor faulty, or incorrect signal. 66 Shutdown due to coolant level 21 Coolant level sensor faulty.

68 Alternator charging incorrectly. 23 Fault code internally in the coordinator. 69 Starter motor function interrupted or not activated. 24 Accelerator/brake. If the accelerator and brake have been operated simultaneously. 82 Engine speed above ref. speed at start 25 Accelerator sensor/idling switch Accelerator sensor/kick-down switch 83 Fault in memory circuit (EEPROM) in control unit. 27 Engine shutdown bypassed. 84 Data transfer to the control unit memory (EEPROM) has been interrupted. 28 Shutdown due to oil pressure 85 Incorrect temperature internally in the control unit. 31 Torque limitation due to oil pressure 86 Internal fault in the control unit: Fault in hardware control.

32 Incorrect parameters for limp home function. 87 Fault in control unit RAM. 33 Battery voltage incorrect or no signal. 88 Internal control unit fault: Memory fault 37 Emergency shutdown switch activated in accordance with CAN message from coordinator. 89 Incorrect seal: Illegal editing of software. 43 CAN circuit faulty in the control unit. 93 Engine speed sensors faulty or not connected . 47 Immobiliser function. Ignition key code incorrect. 94 Shutdown due to high coolant temperature. 48 There is an incorrect CAN message or no CAN message from the coordinator. 96 Torque limitation due to high coolant temperature. 49 Incorrect CAN version in control unit or coordinator.

98 Incorrect voltage supply to one of the sensors . 51 PDE in cylinder 1: The solenoid valve does not work correctly. 99 Internal hardware fault in the processor (TPU) . 52 PDE in cylinder 2: The solenoid valve does not work correctly.