Scania — Removing the ECU wiring

Engine Tier-3 710655- Ch 1 page 40 Removing the ECU wiring Drain the coolant from the engine as described in the work de­ scriptions for the cooling system. 2 Wash clean the rocker covers and the area around them. 3 Remove the inlet pipe between the turbocharger and the air cleaner. 4 Remove the air line to the compressor. The air line is located on the left-hand cable duct. 5 Unplug the connectors from the control unit. 6 Remove the rocker covers. On the 12-litre engine the crankcase ventilation must be removed before the rocker cover on cylinder 1 can be removed. 7 Disconnect the cables from the unit injectors. The screws cannot be removed, but they should be unscrewed as far as possible.

8 Mark the cables with the respective cylinder numbers. 9 Remove the cable duct to which the cables are attached. The unscrew the cable bushings in the lower rocker covers and remove the cables. 10 Remove the charge air sensor and its clamps. 11 On engines fitted with an electricallycontrolled fan, separate the connector on the fan ring, which is connected to the solenoid valve. Remove the cable clamps as well. Note: Handle the engine speed sensors with care. They are magnetic and are sensitive to impacts. 14 Remove engine speed sensor 1 and its clamps. 15 Remove engine speed sensor 2 and its clamps. SHOP MANUAL MT26-31 - 06.2005