Scania — Valve mechanism

Engine Tier-3 710655- Ch 1 page 46 Valve mechanism The purpose of the valve mechanism is to actuate the valves, causing them to open and close at the right times in relation to the position of the crank­shaft and piston. The camshaft is located high up and driven by the timing gears at the rear end of the engine so that it rotates at half the speed of the crankshaft. The camshaft cams (lobes), two for each cylinder, actuate the valve tappets. The pushrods have one end in the tappets and the other end, via the rocker arms, transfers the move­ment from the camshaft cam to the valves.

At one end of the rocker arm is an adjusting screw, the spherical lower end of which rests in the pushrod so that the tappet follows the cam­shaft at all times. The correct clearance can be set with the adjusting screw to ensure that the valve will close properly during combustion. The valves seal against valve seat rings which are pressed into the cylinder head to make a tight fit. The valve seat rings are made of extremely dura­ble material to give them a long service life. Should it be necessary, they are replaceable. With four valves per cylinder, the total valve area becomes greater, making it easier to fill the cylin­der with air.

At the same time, less energy is con­sumed in forcing out the ex­ haust fumes. The effort required for gas flow is reduced and engine ef­ ficiency is improved. This in turn leads to a reduction in fuel consumption. The injector can be located centrally, which improves com­ bustion and results in reduced emissions and lower fuel consumption. SHOP MANUAL MT26-31 - 06.2005