Engine Tier-3 710655- Ch 1 page 52 Replacement of valve seats 1. Remove the valve seat inserts. Use a discarded valve that has been ground so that the diameter of the disc is slightly smaller than the inside diameter of the seat. 2. Fit the valve and weld around it with an electric welder. Cool with water. Turn over the cylinder head and knock the valve stem so that the valve and seat insert fall out. WARNING! ! Use protective goggles. Always turn the cylinder head around with the underside downwards when tapping out the valve seat ring. Otherwise there is a risk of loose splinters causing personal injury. 3. Press in new valve seat inserts. Use drift 512260 and handle 512261.
Cool the drift and valve seat to approximately 80°C in dry ice or using liquid air. Pressing must be carried out rapidly. WARNING! ! 512261 512260 Be careful with the above-mentioned coolants and cooled components. There is a risk of frost injuries. Oversize valve seat inserts can be fitted if the valve seat insert position has been damaged. If this is the case, the seat must be machined using valve seat cutter 512265. SHOP MANUAL MT26-31 - 06.2005