Scania — Fitting the PDE injector

Engine Tier-3 710655- Ch 1 page 59 IMPORTANT! Check the unit injector spring diameter before adjusting and ensure that the correct tool is used when adjusting the unit injector. Note: All work that involves opening the fuel system must be completed in the following way: Start the engine and check for leaks. Allow the engine to run until it is running smoothly. Check and delete any fault codes that are registered in the control unit after the work has been completed. 1 Make sure that the old seal is not at the bottom of the injector seat. Clean the sealing surfaces in the injector seat. IMPORTANT! Always renew the flange screw, O-rings and seal on unit injectors that have been removed.

Make sure all sealing surfaces are clean. 2 Lubricate the unit injector O-rings with O-ring grease, part No. 512086 3 Fit a new sealing washer on the unit injector. A rubber insert will keep the seal in place on the unit injector. WARNING! ! Check that there is no fuel left in the cylinder. If fuel runs into the combustion chamber, it must be removed immediately using a pump. SHOP MANUAL MT26-31 - 06.2005