Scania — General

Engine Tier-3 710655- Ch 1 page 68 General Note! Whenever working on the turbo­charger, observe utmost cleanli­ness. The oil intake and outlet con­ nections must never be left open. A foreign body in the bearing housing can quickly cause total breakdown. Foreign bodies Foreign bodies, such as grains of sand or metal fil­ ings, in the turbine or compressor will damage their blades. This leads to imbalance and bearing wear. Engine out­ put falls off and continued operation could give rise to overheating damage on account of a decrease in the supply of air. Oil leakage With a clogged air cleaner, the vacuum in the intake pipe will be excessive.

There is then a risk that oil mist will be sucked out of the turbo­charger’s bearing hous­ ing. This type of overheating cannot be observed on the coolant temperature gauge. Note! Never attempt to straighten a dam­aged impeller. It will usually break in operation causing the turbo­ charger to break down and may also cause enginedamage. Change the entire turbocharger. If the seal on the turbine side is worn, exhaust gas is blue when idling. If the oil outlet pipe from the turbocharger is dam­aged, there is a risk of oil leaking out through the seals due to lubrication oil pressure. Oil filter The turbocharger rotates at high speed, sometimes above 100.000 rpm.

Air and exhaust leakage Even small leaks in the line between the air cleaner and turbocharger cause dirt deposits on the compres­ sor wheel. The oil lubricates and cools the turbocharger. Efficient lubrication is extremely important. There is no separate turbo filter and the oil passes through the engine oil filter. For this reason, change the oil filter and clean the oil filter assem­bly in accordance with our instruc­ tions. Charge pressure decreases with increased exhaust temperature, causing smoke. In addition, the engine is worn unnecessarily. Exhaust leakage between cylinder head and turbo­ charger also results in lower charge pressure.

Use filter wrench 8388 when removing the oil filter. Cleaning the compressor wheel Low charge pressure can be caused by a dirty com­ pressor wheel, for example. If the oil filter assembly is not cleaned, the oil fil­ter will soon become clogged and its resistance to the flow of oil will increase. - Remove the compressor housing. A valve in the filter holder then opens and allows the oil to pass through the filter without being cleaned (fil­ tered). Unfiltered oil is consequently supplied to the turbocharger with heavy bearing wear as a result. - Wash the compressor wheel using white spirit and a brush. - Fit the compressor housing and measure charge pressure again.

The valve is designed for genuine Moxy filters and only these should be used. Note! The compressor wheel must not be removed from the shaft. Imbalance may occur when it is refit­ ted. Removing oil filter SHOP MANUAL MT26-31 - 06.2005