Engine Tier-3 710655- Ch 1 page 67 Turbocharger The purpose of the turbocharger is to increase the volume of air entering the engine’s cylinders. With more air the engine can burn more fuel and so de velop more power and achieve cleaner combustion than a corresponding engine without supercharg ing. The turbocharger is driven by the engine’s exhaust gases and consists of a turbine part and a com pressor part. The compressor part compresses the engine’s intake air. The compressor wheel is mounted on the same shaft as the turbine wheel. This shaft runs in a bear ing housing between the compressor and turbine.
Higher power output from the engine gives more exhaust fumes and the increased exhaust means that the turbine wheel and therefore the compres sor wheel rotate faster. In this way, the quantity of air is adapted to engine requirements without any special control devices. The turbocharger wheel rotates extremely fast. At full power, speed is about 100,000 rpm. At the same time, the temperature on the exhaust side of the turbine wheel is above 600°C. This makes big demands on the rotating parts in regard to balance, cooling and lubrication. The shaft is mounted in two bushings which rotate freely in the bearing housing.
The bearing hous ing seals for the turbine and compressor consist of seals which are similar to piston rings. SHOP MANUAL MT26-31 - 06.2005