Scania — Assembling piston and connecting rod

Engine Tier-3 710655- Ch 1 page 82 Assembling piston and connecting rod 1. Clean the piston and its rings thoroughly without scratching the sides of the ring grooves. The oil holes in the piston should be cleaned using a suitable drill. 2. Make sure the piston ring gaps do not exceed the permitted limit. Place the piston rings in the cylinder liner and measure the gap using a feeler gauge. For permitted gap, see section entitled Specifications, piston rings. 3. Fit the piston rings using tool 8395. The oil scraper ring has an expander. Pistons rings marked with TOP must be turned with TOP face up. 4. Oil all the bushings, the gudgeon pin hole and the gudgeon pin before assembling. 5.

Place one of the retaining rings in the piston. 6. Turn the piston and connecting rod as illustrated. The arrow mark should point forward on the engine. 7. Insert the gudgeon pin using tool 8005 and fit the second retaining ring for the gudgeon pin. 8005 SHOP MANUAL MT26-31 - 06.2005