Engine Tier-3 710655- Ch 1 page 83 Cylinderblock The cylinder block is a one-piece casting. It has 5 cylinder bores. There is a separate cylinder head for each cylinder. The seal between cylinder block and cylinder head consists of a steel/elastomer gasket. Seals are bonded in place at the oil and coolant passages. Cylinder liner The cylinder liners are of the “wet” type, i.e. they are surrounded by coolant. To ensure a good seal, the edge of the cylinder liner protrudes slightly above the surface of the cylinder block. This ensures that the cylinder head gasket is pressed against the cylinder head. SHOP MANUAL MT26-31 - 06.2005