Engine Tier-3 710655- Ch 1 page 86 Measuring the cylinder liner height 1. Thoroughly clean the cylinder block liner shelf, the face around the cylinder, the cylinder liner shelf and the upper face of the cylinder liner. 2. Fit the cylinder liner without O-rings and twist down by hand into position. 3. Lift out the liner and wipe the liner shelf in the cylinder block and the cylinder liner shelf. 4. Insert the cylinder liner without O-rings and twist it down into position again by hand. 5. Place straight edge 87 198 with dial gauge 98 075 on the liner and zero the dial gauge to the liner (A).
Slide the tip of the dial gauge over to the cylinder block (B) and measure the height of the liner (A-B) as illustrated. A = Measuring surface on cylinder liner B = Measuring surface on cylinder block C = Tip of dial gauge D = Cylinder liner height D = A-B Measuring cylinder liner height 6. Measure each liner at two diametrically opposite points transversely across the engine. - The cylinder liner must be slightly above the face of the cylinder block. - The difference between the two measurements on the same liner must not exceed 0.02 mm. - The height of the cylinder liner D (=A-B) above the block should be 0.20 – 0.30 mm. SHOP MANUAL MT26-31 - 06.2005