5. Failure Diagnosis P0251 IMV control fault 1. Overview 2. Condition for Running Diagnostic During engine running 3. Condition for Setting the Fault Code If IMV PWM demand is out of range, fault code is raised. 4. Condition for Clearing the Fault Code If IMV PWM demand is in the range, fault code is cleared 5. Inspection Items 5 - 121 Code Causes Impact P0251 Faulty IMV. Fault with IMV wiring or connectors. ECU fault (IMV driver/processing within ECU). Faulty ECU live or ground. Fault with ECU wiring or connectors CE lamp ON Torque Reduction Lv0 NO ECU Pin Description 1 177 Inlet Metering Valve PWM 2 - Pbatt Step Inspection Standard Value YES NO 1 P0251 is occurred on diagnostic tool?
Step 2 2 Fault of type IMV or rail pressure sensor? First, fix the corresponding fault Step 3 3 DTC link to High Pressure control? Step 4 No problem 4 Check that: * fuel feed circuit is in good condition * there is diesel fuel present in the system * there is no air (no bubbles or emulsion in the pipes) * there is enough fuel pressure in inlet pump * there are no high pressure circuit leaks * there is diesel fuel of the correct quality and type Low pressure circuit faulty? Repair the low pressure circuit Step 5 5 According to engine start or not, different tests are to be done. Does engine start? Step 6 Step 7 6 Perform "DYNAMIC IMV TEST" Faulty IMV?
Replace IMV Step 8 7 Perform "STATIC INJECTOR BACKLEAK TEST" Carry out the "tube test: Result? Replace corresponding injector(s) Replace HP pump 8 Perform "DYNAMIC INJECTOR BACKLEAK TEST" Backleak above limit? Replace corresponding injector(s) Step 9 9 Perform "PUMP PRESSURE BUILD CAPACITY" This test need specific equipment "hydraulic-T" Result? End Replace HP pump