5. Failure Diagnosis P062D Injector Bank 1 electric or SPI fault 1. Overview 2. Condition for Running Diagnostic During engine running 3. Condition for Setting the Fault Code The injector bank 0 high side driver feedback voltage is constantly monitored. If the voltage is lower/higher than the calibrated threshold, then the fault is set. Or SPI (Serial Peripheral Interface) has a problem 4. Condition for Clearing the Fault Code The injector bank 0 high side driver feedback voltage is constantly monitored. If the voltage is inside the calibrated threshold range, then the fault is cleared. 5.
Inspection Items 5 - 128 Code Causes Impact P062D Injector bank #1 has shorted to ground or battery or SPI (Serial Peripheral Interface) fault CE lamp Flashing Low idle RPM increase (SPI fault - CE lamp ON Torque Reduction Lv0) NO ECU Pin Description 1 126 Fuel Injector LSD1A 2 127 Fuel Injector HSD1A NO ECU Pin Description 1 125 Fuel Injector LSD2A 2 103 Fuel Injector HSD2A Step Inspection Standard Value YES NO 1 P0602D is occurred on diagnostic tool? Step 2 2 After let the machine is in safety area and turn-off the key switch. Step 3 3 Check injector connections corresponding to fault bank Connection problem?
Do necessary repair Step 4 4 Disconnect injectors and key on Problem still present? Step 7 5 Check ECU Connection Connection problem? Do necessary repair Step 6 6 Clear fault then key off then reconnect ONE injector then key on Problem back? Step 7 Step 8