6. About the engine 10. Remove the intake stake. 12. Remove the turbocharger. 1 C A B D A D B C E EDL013005A EDL013007A 1) Loosen the flange hex bolt (D). 2) Remove the boost pressure sensor (C). 3) Loosen 3 flange hex bolts (B). 4) Remove the gasket and the intake stake (A). 2 11. Remove the common rail and the injection pipes. A C B A C B D E EDL013008A D 1) Disconnect the oil return pipe. Note) The oil return pipe is that TYPE-1 is (E) and TYPE-2 is (D) . EDL013006A 2) Loosen 2 hollow screws from the oil delivery pipe. 1) Loosen the fixing bolt (E). 2) Loosen the nuts of the fuel injection pipes. Note) Loosen the fixing bolt(D) if the engine is TYPE-1.
3) Disconnect the oil delivery pipe (C). 4) Loosen 4 flange hex nuts (B) 3) Remove 4 fuel injection pipes (C) and (D). 5) Remove the gasket and the turbocharger (A). CAUTION Do not reuse fuel injection pipes; replace them with new ones. If fuel injection pipes are reused it may allow foreign substances into the fuel pipes or cause oil leaks from bolt clamping and cause a critical fault in engine performance. 4) Loosen 2 collared hex bolts (B) of the common rail. 5) Remove the common rail (A) from the intake manifold. 6 - 9