Doosan Infracore D18NAP — Procedure of Disassembling an Engine

6. About the engine 13. Remove the oil filter assembly. 15. Remove the knock sensors. D A C B A B EDL01300 9 A EDL013011A 1) Loosen thefixing bolt (D). 1) Loosen 2 fixing bolts (B). 2) Disconnect the coolant hose (C). 2) Remove 2 knock sensors (A) from the cylinder 3) Loosen 5 flange hex bolts (B). block. 4) Remove the 3 O-rings and the oil filter assembly (A). 16. Remove the rear lifting hook. CAUTION 1 Oil in the filter may run down while removing the oil filter. Be careful not to contaminate the other parts by using a cloth when removing the filter. After replacing the oil filter, wipe clean any other parts which the oil has touced. 14. Remove the intake manifold.

A B B EDL013012A C A 2 A EDL013010A B 1) Remove the boost temperature sensor (C). 2) Loosen 8 flrange hex bolts (B). 3) Remove the gasket and the intake manifold (A) from the cylinder block. EDL013013A 6 - 10