Doosan Infracore D18NAP — Procedure of Disassembling an Engine

6. About the engine 1) Loosen 2 fixing bolts (B). 19. Remove the thermostat. 2) Remove the rear lifting hook (A). 17. Remove the front lifting hook. A C E B A D B EDL013016A 1) Remove the water temperature sensor (E). EDL013014A 2) Disconnect the rubber hose (D). 1) Loosen 3 fixing bolts (B). 2) Remove the front lifting hook (A). 3) Loosen the flange nut and spcae bolt (C). 4) Loosen the 3 flrange hex bolts (B). 5) Remove the thermostat (A). 18. Remove the EGR cooler assembly and the cam position sensor. 20. Remove the exhaust manifold pipe (Only TYPE-1). C A B A C B E D EDL013015A EDL013017A 1) Loosen the fixing bolt (E). 1) Loosen 3 flange hex nuts (C). 2) Loosen 3 flange hex bolts (B).

2) Remove the cam position sensor (D). 3) Disconnect the rubber hoses (C). 3) Remove the exhaust manifold pipe (A). 4) Loosen 3 flange hex bolts (B). Note) The exhaust mainfold pipe (A) is only TYPE-1. 5) Remove the EGR cooler assembly (A). CAUTION CAUTION Exhaust gas make engine parts extremely hot. Only remove the parts when they have fully cooled to prevent burns. Exhaust gas make engine parts extremely hot. Only remove the parts when they have fully cooled to prevent burns. 6 - 11