6. About the engine 37. Remove the oil suction pipe and oil delivery pipe. 39. Remove the piston. D E F B C A C D B A G EDL013035A EDL022038A 1) Loosen 3 hex bolts (D) and 2 hex bolts (C). 1) Remove 2 snap rings (B) from the both ends of the 2) Remove the oil suction pipe and the oil delivery piston. 3) Remove 3 O-rings (A). pipe (B). 3) Remove the piston (A) from the connecting rod (G). 2) Remove the piston pin (C). 4) Remove the 1st ring (D), the 2nd ring (E), and the 38. Remove the connecting rods assembly. oil ring (F) with the piston ring plier (T7621010E). 40. Remove the timing gear case. C A A B D B E EDL013036A D E C 1) Loosen 6 connecting rod bolts (E).
EDL013037A 2) Remove the lower connecting rod caps (D). 3) Remove the connecting rods (C). 1) Loosen the fixing bolt (D). 2) Remove the crank speed sensor (C). CAUTION 3) Loosen 16 hex bolts (B). 4) Remove the timing gear case (A). Be careful not to mix disconnected connecting rods, connecting rod caps, and removed connecting rod bolts as they are set aside. 5) Remove the front oil seal (E) with the oil seal disassembly jig (850306-00078). 4) Remove the upper connecting rod bearings(A) CAUTION and the lower connecting rod bearings (B). Do not reuse the oil seal but replace them with new ones. 6 - 16