6. About the engine Procedure of Assembling Engine 2. Attach the valve tappets. CAUTION A Cleanse all disassembled and disconnected parts. Especially, clean the oil and coolant path with compressed air and check if there is any resistance. Arrange general tools and special tools for engine assembly. Prepare clean engine oil to be applied on each sliding component. Prepare repair materials such as sealant and gaskets. Replace used gaskets, seal rings, and expendable parts with new ones. Each bolt should be tightened with the specified tightening torque in the order of tightening; however, excessive tightening torque should be avoided.
Ensure that all engine parts are successfully operating after reassembly. Check if any bolts are loose after the first assembly. Always keep hands clean during assembly. EDL013046A 1) Apply a mixture of engine oil and molykote on the surface where the cylinder block and the valve Note) Engine oil : MOLYKOTE = 1 : 5 tappets are assembled. 2) Connect 6 valve tappets (A). Assemble the engine in the following order. 1. Attach the oil spray nozzles. 3. Attach the camshaft. B A A B EDL013047A EDL013045A 1) Attach 3 oil spray nozzles (A) to the corresponding 1) Apply engine oil in the cam hole of the cylinder block. 2) Apply engine oil on the camshaft journal. pins.
Note) Ensure that the camshaft journal and the inside 2) Tighten 4 relief valve screws (B) at a tightening torque of 2.0 kgf m . of the cylinder block bush are normal. 3) Align the thrust washer with the cylinder block part. 4) Tighten 2 hex bolts (B) at a tightening torque of 2.2 kgf m. Note) Temporarily mount one hex bolt manually and then rotate the camshaft gear to tighten the other hex bolt. 5) The camshaft end play is 0.1 ~ 0.2 mm. 6 - 21