Doosan Infracore D18NAP — Procedure of Assembling Engine

6. About the engine CAUTION Align the key groove of the cylinder block with the key of thrust washer. 4. Attach the crankshaft. Note) The class of the main bearing is as follows. B C A EDL013044A 1) Attach 4 upper main bearings (A) to the cylinder block. CAUTION Note) For the method to measure the inside diameter of the cylinder block main bearing bore, refer to Chapter 11 Cylinder Block/Head. Bearings with a groove are the upper main bearings on the cylinder block side and bearings without a groove are the lower main bearings on the crank case side. Remove foreign substances such as residues and LOCTITE from the inside of the main bearings and the oil seal assembly bore.

Do not apply engine oil on the surface where the cylinder block and the main bearings are assembled. Note) For the method to measure the crankshaft main journal diameter, refer to Chapter 13 Others/ Driving Units. The class of the main bearing bore inside diameter of the cylinder block is engraved on the cylinder block and the class of main journal diameter of the crankshaft is engraved on the crankshaft. For the engraving positions, see the Engine Unique Number of Chapter 3 (Performance and Specifications).

Select the proper main bearing class by checking or measuring the class of main bearing bore inside diameter of the cylinder block and the class of the main journal diameter of the crankshaft. The upper main bearing class should be same as the lower main bearing class. 2) Sufficiently apply engine oil on the surface where the upper main bearings and the crankshaft are assembled. 3) Attach the crankshaft (B). 4) Attach 2 thrust washers (C).

6 - 22 Item Specified Value Camshaft end play 0.1 ~ 0.2 mm Block journal bore Crankshaft main journal diameter Class A Class B Class C Class A YELLOW BLUE BLUE Class B YELLOW YELLOW BLUE Class C RED RED YELLOW Block main bearing bore diameter Specified Value Class A 62.000 ~ 62.007 mm Class B 62.007 ~ 62.014 mm Class C 62.014 ~ 62.021 mm Crankshaft main journal diameter Specified Value Class A 57.955 ~ 57.960 mm Class B 57.960 ~ 57.965 mm Class C 57.965 ~ 57.970 mm Main bearing thickness Specified Value BLUE 1.995 ~ 2.000 mm YELLOW 2.000 ~ 2.005 mm RED 2.005 ~ 2.010 mm