Doosan Infracore D18NAP — Procedure of Assembling Engine

6. About the engine 5. Attach the crank case. 4 4 15 16 3 3 11 12 7 8 2 2 6 5 1 1 10 9 14 13 F E EDL013049A EDL013048A H G B I A J EDL013050A EDL013043A 1) Apply 4 lower main bearings (A) to the crank case. CAUTION C D Bearings with a groove are the upper main bearings on the cylinder block side and bearings without a groove are the bottom main bearings on the crank case side. Do not apply engine oil on the surface where the cylinder block and the main bearings are assembled. The class of main bearing bore inside diameter of the cylinder block is engraved on the cylinder block and the class of main journal diameter of the crankshaft is engraved on the crankshaft.

For the engraving positions, see the Engine Unique Number of Chapter 3 (Performance and Specifications). Select the proper main bearing class by checking or measuring the class of main bearing bore inside diameter of the cylinder block and the class of main journal diameter of the crankshaft. The upper main bearing class should be same with the lower main bearing class. EDL013042A 6 - 23