Doosan Infracore D18NAP — Procedure of Assembling Engine

6. About the engine 2) Sufficiently apply engine oil on the surface where the lower main bearings and the crankshaft are assembled. 3) Apply LOCTITE 5902 on the crank case assembly surface. Apply it on the rear part of the engine (F) with the diameter ш 6 ± 0.5 mm and on the front part 10) Attach the rear oil seal assembly jig (860104- 02048) to the real oil seal (G) of guide (I). of the engine (E) with the diameter ш 3 ± 0.5 mm. 11) Attach the rear oil seal assembly jig (860104- CAUTION 02048) guide (I) to the crankshaft (H). Keep clean liquid gasket dispensing surface. Dispensing line should not be snapped.

12) Mount the rear oil seal assembly jig (860104- 02048) holder (J) to the guide (I). 13) Turn the bolt on the center of the rear oil seal 4) Attach the crank case(B). assembly jig until the rear oil seal assembly jig CAUTION (860104-02048) holder (J) contacts with the cylinder block surface and the crank case surface Be careful to attach the cylinder block and the crank case in the right direction. Assemble bed plate in 5 minutes after dispensing liquid gasket. Do not pressurize inside crank case in 25 minutes after dispensing liquid gasket. Remove all liquid gasket inside oil seal bore and front/rear side of crank case after assembly and press in the rear oil seal (G).

CAUTION Be careful in noting the direction of the oil seal assembly and ensuring that the oil seal surface faces the outside of the engine. Be careful of the depth of the oil seal when attaching it. Be careful not to damage the oil seal. 5) Temporarily mount 8 main bearing cap bolts (C) in order from (1) - (4). Attach the oil seal without applying lubrication, coolant, fuel, LOCTITE, or silicon. 6) Tighten 8 main bearing cap bolts (C) at a Remove foreign substances such as residues and LOCTITE from the oil seal assembly bore. tightening torque of 5.5 kgf•m( ± 5%) + 90°( ± 4°) + Do not reuse the oil seal; replace it with a new one. 90°( ± 4°) by using the angle method. .

CAUTION Be careful not to damage the oil seal when attaching it. Tighten the main bearing cap bolts with the angle method. Tighten the main bearing cap bolts in order from (1) - (4). The front engine direction is the water pump direction and the rear engine direction is the flywheel direction. Attach the crank case by tightening the main bearing cap bolts and then the collared hex bolts. 6. Attach the oil pump. B 7) Temporarily tighten 16 collared hex bolts in order from (5) - (16). 8) Tighten 12 collared hex bolts (D) at a tightening torque of 2.2 kgf m. CAUTION A C Tighten collared hex bolts in order from (5) - (16).

The front engine direction is the water pump direction and the rear engine direction is the flywheel direction. Rotate the crankshaft 2 or 3 times to check for defects. EDL013041A 1) Align 2 O-rings (A) to the engine oil inlet and outlet. 2) Align the oil pump (B) with the pin and press it to 9) The crankshaft end play is 0.1 ~ 0.31 mm . the cylinder block as much as possible. 6 - 24 Item Specified Crankshaft end pla y 0.1 ~ 0.3