6. About the engine 3) Tighten 4 hex bolts (C) at a tightening torque of 2.2 kgf•m. CAUTION 4) The backlash between the crankshaft gear and the oil pump gear is 0.006 ~ 0.259 mm. Make sure that you are attaching the idle gear so that its engraving faces the outside of the cylinder block. Backlash between the crankshaft gear and the oil pump gear 0.06 ~ 0.259 mm Item Specified Value 3) Position the idle gear engraving (D) between the camshaft gear engravings (E). Note) You can see two camshaft gear engravings and one idle gear engraving. CAUTION Make sure that the O-rings have been mounted. Be careful not to damage the O-rings while mounting them.
CAUTION Make sure that the idle gear engraving is positioned between the two camshaft gear engravings. 7. Attach the idle gear. 4) Position the crankshaft gear engraving mark (G) between the idle gear engravings (F). Note) You can see one crankshaft gear engraving and two idle gear engravings. A CAUTION B Make sure that the crankshaft gear engraving is positioned between two idle gear engravings. C 5) Align the flange hex holes of the cylinder block to 6) Attach the idle gear shaft (B). those of the idle gear shaft. CAUTION EDL013040A Make the oil hole of the idle gear shaft(B) face the top surface of the cylinder block. 7) Tighten 3 flange hex bolts (C) at a tightening torque of 4.4 kgf m.
D E 8) Backlash of the idle gear and the crankshaft gear is 0.087 ~ 0.200 mm. F 9) The backlash between the idle gear and the G camshaft gear is 0.087 ~ 0.211 mm. EDL022052A 1) Apply engine oil to the inside of the idle gear bush in the idle gear. 2) Attach the idle gear (A). 6 - 25 Item Specified Value Backlash between the idle gear and the crankshaft gear 0.087 ~ 0.200 mm Item Specified Value Backlash between the idle gear and the camshaft gear 0.087 ~ 0.211 mm