Doosan Infracore D18NAP — Procedure of Assembling Engine

6. About the engine 8. Attach the fuel injection pump. 4) Position the idle gear engraving (F) between the injection pump drive gear engravings (E). Note) You can see two injection pump drive gear engravings and one idle gear engraving. D 5) The backlash between the fuel injection pump and the idle gear is 0.087 ~ 0.2 mm. C Item Specified Value A Backlash between the fuel injection pump and the idle gear 0.087 ~ 0.2 mm B 6) Tighten the flange hex nuts (D) at a tightening torque of 6.5 ± 0.5 kgf m. EDL013039A 9. Attach the timing wheel. E F A EDL013051A EDL013038A 1) Attach the fuel injection pump(A). 1) Attach the timing wheel (A).

Note) To replace stud bolts, apply LOCTITE 272 to the stud bolts and then press in those bolts. CAUTION 2) Tighten 3 flange hex nuts (B) at a tightening torque of 2.2 kgf m. Be careful not to damage the teeth of the timing wheel. 3) Be careful to mount the injection pump drive gear (C) with attention to the pin direction. Note) If the gear mark is visile, place the idle gear mark between the marks of the fuel injection pump drive gear. But if not visible , install the fuel injection pump regardless of the position of gear mark. CAUTION Ensure that you are attaching the injection pump drive gear so that its engraving faces the outside of the cylinder block.

Ensure that the pin direction is the opposite direction of the idle gear. 6 - 26