Doosan Infracore D18NAP — Procedure of Assembling Engine

6. About the engine 11. Attach the piston. CAUTION D E F Be careful to mind the direction when attaching the piston and the connecting rod. Place the product number on the top surface of the piston, the larger side of the valve contact. and the bumpy side of the piston to make them face the front of the cylinder block. Make the bumpy side of the connecting rod face the front of the cylinder block. Make the direction of the bumpy side of the piston the same as that of the bumpy side of the connecting rod. The class of the inside diameter of the cylinder block piston bore is engraved on the cylinder block and the piston class is engraved on the top surface of the piston.

For the engraving positions, see the Engine Unique Number of Chapter 3 (Performance and Specifications). Check or measure the class of the inside diameter of the cylinder block piston bore and the cylinder block piston to select a suitable piston class. Be careful in noting the direction of the piston and the connecting rod when attaching them. Make the direction of the bumpy side (H) of the piston the same as that of the bumpy side (I) of the connecting rod. If the gap between the piston ring and the small end of the connecting rod is out of the range of 0.025 - 0.043, replace the more worn of the two.

A C B G EDL022038A H I Note) The classes of the cylinder block and the piston are as follows. EDL022054A 1) Mount the 1st ring (D), the 2nd ring (E), and the oil ring (F) with the piston ring plier (T7621010E). CAUTION Ensure that the ‘R’ mark of the piston ring faces the top surface of the piston. Make the piston ring position dislocated to 120 degrees. 2) Apply engine oil on the piston pin (C). 3) Align the pin hole of the connecting rod small-end with that of the piston (A). Note) For the method to measure the inside diameter of the cylinder block piston bore, refer to Chapter 11 (Cylinder Block/Head). Note) The piston class is engraved on the top surface of the piston.

4) Attach the piston pin (C). 6 - 28 Inside Diameter of Cylinder Block Piston Bore Piston Class A Class B Class A O - Class B - O Inside Diameter of Cylinder Block Piston Bore Specified Value Class A 89.990 ~ 90.000 mm Class B 90.000 ~ 90.010 mm Piston Specified Value Class A 89.920 ~ 89.930 mm Class B 89.930 ~ 89.940 mm