Doosan Infracore D18NAP — Water pump Disassembly

7. Cooling System Water pump General Information The water pump prevents the engine from being 3. Remove the water pump pulley. overheated by combustion heat during engine operation and delivers coolant from the radiator to each part of the engine. A B Water pump Disassembly 1. Drain coolant. 1) Check if the engine and radiator are cooled. 2) Place a container in front of the coolant drain plug. 3) Remove the radiator cap. 4) Remove the coolant drain plug of the radiator and then drain coolant. 5) After completing coolant drain, reconnect the coolant drain plug. EDL013023A DANGER 1) Loosen 4 flange hex bolts (B). 2) Remove the water pump pulley (A).

If the radiator cap is opened while the engine is hot, hot water will spurt out and may cause serious burns. Open the radiator cap after making sure that the engine has been fully cooled. 4. Remove the water pump. B A Mark and separately manage the containers for storing coolant from beverage containers to avoid confusion. See a doctor immediately in case of drinking coolant. C WARNING D Discard coolant according to the regulations set forth by the relevant authorities. Disposing of discharged coolant into the ground, sewers, drains, rivers, or the sea will cause serious environmental pollution.

Violation of regulations when discarding engine oil without observing the handling regulations, will be punished. EDL013024A CAUTION 1) Loosen 2 flange hex nuts (D) and 4 hex bolts (C). Be careful not to get coolant on any belts or electric apparatus when replacing the coolant. 2) Remove the water pump (B) and the gasket (A). 2. Remove the V-belt. 7 - 6