Doosan Infracore D18NAP — Disassembly of Oil Filter Assembly

8. Lubrication System Oil Filter Assembly General Information The oil cooler cools oil with coolant and the oil filter removes the foreign substances from the oil. 3. Remove the oil filter assembly. Disassembly of Oil Filter Assembly D 1) Place a container under the engine to drain the 1. Drain the engine oil. C engine oil. 2) Remove the oil cap. A 3) Remove the drain plug and drain the engine oil. WARNING B Discard oil according to the regulations set forth by the relevant authorities. Disposing of discharged oil into the ground, sewers, drains, rivers, or the sea will cause serious environmental pollution.

Violation of regulations when discarding engine oil without observing the handling regulations, will be punished. EDL01300 9 A 1) Loosen thefixing bolt (D). 2) Disconnect the coolant hose (C). 3) Loosen 5 flange hex bolts (B). 4) Remove the 3 O-rings and the oil filter assembly (A). CAUTION 2. Remove the oil level gauge. Oil in the filter may run down while removing the oil filter. Be careful not to contaminate the other parts by using a cloth when removing the filter. After replacing the oil filter, wipe clean any other parts which the oil has touced. C A 4. Disassemble the oil filter assembly. B F A 1) Remove the oil level gauge (C). EDL013003A E 2) Loosen the flange hex bolt (B).

3) Disconnect the oil level gauge gauide tube (A). D C B EDL013072A 1) Remove the oil filter(A) with the filter wrench. 8 - 12