Doosan Infracore D18NAP — Assembly of Oil Filter Assembly

8. Lubrication System 2. Attach the oil filter assembly. CAUTION Oil in the filter may down while removing the oil filter. Becareful not to contaminate the other parts by using a cloth when removing the filter. After replacing the oil filter, wipe clean any other parts which the oil has touched. D 2) Disconnect the coolant hose (B). C 3) Loosen 4 flange hex bolts (C). A 4) Remove the oil cooler (D). 5) Remove the 3 O-rings (E) from the oil filter head (F). B Check of Oil Cooler 1. Check if the coolant inlet of the oil cooler is dam- EDL01300 9 A aged and if coolant has leaked. 1) Attach the 3 O-rings and the oil filter assembly (A). 2.

Check if the oil inlet and outlet of the oil cooler are 2) Tighten 5 flange hex bolts (B). 3. Check if the exterior of the oil cooler is damaged damaged and if oil has leaked. 3) Connect the coolant hose (C) 4) Tighten the fixing bolt (D). and leakage has occurs. CAUTION Assembly of Oil Filter Assembly Make sure that the O-rings have been mounted. Be careful not to damage the O-rings while mounting them. 1. Assemble the oil filter assembly. 3. Attach the oil level gauge. F A E C A D C B B EDL013072A 1) Attach the 3 O-rings (E) to the oil filter head (F). 2) Attach the oil cooler (D) 3) Tighten 4 flange hex bolts (C). EDL013003A 4) Connect the coolant hose (B).

1) Attach the oil level gauge guide tube (A) in the 5) Wipe the surface on which the oil filter(A) is cylinder block. 6) Temporarily tighten the oil filter (A) by hand. attached clean. 2) Tighen the flange hex bolt (B) at a tightening torque of 1.0 kgf m. 7) Tighten the oil filter at a tightening torque of 16 ~ 3) Insert the oil level gauge (C). 20 N m with the filter wrench. 8 - 13