Doosan Infracore D18NAP — Injector Disassembly

9. Fuel System 3. The injector is fully open. (injecting fuel) The valve control plunger is stopped at the upper position because fuel is full as fuel flows from the fuel delivery hole. At this time, the injector nozzle is fully open and fuel is injected to the combustion chamber at the pressure equal to that of the common rail. 2 A 4. The injector is closed. (ending fuel injection) As soon as the supply to the solenoid vale of the injector is blocked, the valve spring applies force to the armature downward and the valve ball closes the discharge hole. The armature consists of two components. The armature plate is guided by the driving shoulder and pressed downward.

However, in this case, an overspring is used. It is a return spring that prevents the force from being applied to the armature and the valve ball. As the discharge hole is closed, fuel is delivered from the delivery hole and generates pressure in the control chamber. This fuel pressure is equal to the pressure of the common rail and puts pressure on the valve control plunger through the end face of the valve control plunger. As a result, the force of the spring is added to the pressure exceeding the pressure of the nozzle chamber. Therefore, the nozzle needle is closed. The speed of closing the nozzle needle is decided by the flow that passes through the delivery hole.

As soon as the nozzle needle is positioned to the stop position, fuel injection is blocked. EDL013002A 1) Remove the breather hose (A). CAUTION Do not reuse the clamps but replace with new ones. 2. Remove the common rail and the injection pipes. C A B E D Injector Disassembly 1. Remove the breather hose. 1 EDL013006A 1) Loosen the fixing bolt (E). 2) Loosen the nuts of the fuel injection pipes. 3) Remove 4 fuel injection pipes (C) and (D). A CAUTION Do not reuse fuel injection pipes; replace them with new ones. If fuel injection pipes are reused it may allow foreign substances into the fuel pipes or cause oil leaks from bolt clamping and cause a critical fault in engine performance.

EDL013001A 4) Loosen 2 collared hex bolts (B) of the common rail. 5) Remove the common rail (A) from the intake manifold. 9 - 7