9. Fuel System 1. Comparing to the existing injection characteristics, A. Fuel injection pump F. Fuel injection pipe for injector #1 the common rail requires the ideal fuel injection as follows. The fuel injection amount and the B Injector G. Fuel injection pipe for injector #2 injection pressure work independently from each other, satisfying conditions for all engines. C Common Rail H. Fuel injection pipe for injector #3 2. It should be available to adjust the injection amount to low for the ignition delay time, i.e., the D. Pressure sensor I. Fuel return hose E. Fuel supply Fuel injection pipe period from starting fuel injection to starting combustion at the early stage of fuel injection.
3. The common rail system is a modulized system. Note) The front engine direction (F) is the water pump direction and the rear engine direction (R) is the flywheel direction. Generally, the following components take key roles of the injection characteristics. 1) Injector solenoid valve installed on the cylinder head 2) Common rail 1) After the injector has used fuel from the common rail for fuel injection, the pressure in the common 3) Fuel high-pressure pump rail is actually kept consistently. The fuel pressure 4) Electronic Control Unit (ECU) is measured by the common rail pressure sensor 5) Crankshaft RPM sensor and kept as a desired value by the pressure adjustment valve.
The pressure control valve Injection Pipe controls the fuel pressure up to 1,800 bar in the 1. Fuel high-pressure pipe 2) The common rail stores the fuel pumped from the common rail. 1) The fuel high-pressure pipe transfers high-pressured high-pressure fuel pump at the high pressure. fuel of 1,800 bar. Therefore, special materials are After the injector has used fuel from the common rail for fuel injection, the pressure pulsation in the used for fuel line to stand the maximum pressure of the system and the high-pressure changes which common rail is actually kept consistently because are generated while fuel is injected. The high- of the volume of the common rail.
The fuel pressure pipe uses both the external diameter of ш pressure is measured by the common rail pressure sensor and kept as a desired value by the 6.35 and the bore of ш 3.0. In addition, the length pressure adjustment valve. The pressure control of the fuel high-pressure pipes between the common rail and the injector should be identical valve controls the fuel pressure up to 1,800 bar in the common rail. and installed as short as possible. 3) Doosan's common rail fuel injection system separates the high-pressure apparatus from the fuel injection apparatus. The ECU decides the fuel 2.
Common rail amount and the fuel injection timing and pressure G F for the optimum performance and injects fuel in the cylinder. H I D 3. Common rail pressure sensor B 1) Fuel flows from the common rail into the common rail pressure sensor through the path. The end of the pressure sensor is sealed with diaphragm. The C pressurized fuel reaches the diaphragm of the E sensor through the hole. The sensor which converts the fuel pressure to the electrical signal A is connected to this diaphragm and the signal EDL013075A amplifies the measurement signal. The signal is sent to the ECU and input in the evaluation circuit. 9 - 14