9. Fuel System sensor and the air temperature sensor to operate with the best conditions for engine operation. 1) The accelerator pedal sensor sends the data generated when a driver presses the accelerator pedal to the ECU. The voltage value is generated by the potentiometer in the accelerator pedal sensor. The pedal position is calculated with the programmed characteristics curves. 2. Crankshaft RPM sensor 1) Position of the piston in the combustion chamber is very important. Pistons of all engines are connected to the crankshaft via the connecting rods. The crankshaft RPM sensor installed in the flywheel housing provides information on the position of all pistons.
The rev-speed is defined as Revolutions per Minute (RPM) of the crankshaft. The key input parameters are calculated by the ECU by using the signals received from the crankshaft RPM sensor. 5. Fuel temperature sensor 1) This sensor measures the fuel temperature in the fuel pump. 6. Boost pressure and temperature sensor 1) The boost pressure and temperature sensor is connected to the intake stake via the O-ring. It measures the absolute pressure and temperature in the intake stake. 2) The output signal is input to the ECU and the boost pressure is calculated based on the ECU- programmed characteristics curves. 3.
Camshaft RPM sensor 1) The camshaft RPM sensor controls the intake and exhaust valve of the engine. It revolves at the half of the crankshaft speed and determines whether the camshaft position is at the compression stage or the exhaust stage when the piston is moving toward the top dead point. This information cannot be determined by the crankshaft RPM sensor. However, while the engine is normally operating, the information given by the crankshaft RPM sensor is enough to define the engine state. It means that the ECU receives information of the engine from the crankshaft RPM sensor if the camshaft RPM sensor cannot sense the engine state while the vehicle is running. 7.
Oil pressure and temperature sensor 1) The engine oil pressure and temperature sensor senses the temperature and pressure of engine oil and sends the data to the ECU. 8. Common rail pressure sensor 1) It is installed at the end of the common rail, measuring the instantaneous internal pressure of the common rail. 9. Engine coolant temperature sensor 1) The engine coolant temperature sensor perceives the temperature of the engine coolant sends the data to the ECU. 4.
Accelerator pedal sensor Fuel Injection from the Injection Pump Common rail fuel injection Main injection pressure Main injection pressure Max injection pressure Common rail pressure Fuel delivery start Fuel injection start Injection pressure Injection pressure Time Time EDL0213004A The injection characteristics of the common rail are as follows. 9 - 13 Fuel injection